Create It Yourself

Give Your Jewellery Some Love

Show off your sparkles with this creative, heart-shaped jewellery holder

Print Page
  1. Step1_Cut_Finished

    Use your jigsaw to cut the 25x75mm wood into 6 pieces, each 405mm in length, and one at 355mm (the shorter piece will be used as your back fastening piece).

  2. Step2_Trace

    Line up pieces of wood. Draw half of a heart into one side of the pieces, as seen in image below. (After you cut the first 3 pieces you’ll flip them and trace them onto the remaining 3 pieces so that your project is symmetrical.)

  3. Step3_Cut Tracings

    Secure wood to work bench, cut tracings with your jigsaw. For smaller pieces, you may want to use clamps for ease and accuracy.

  4. Step4_Cut Finished

    Flip the pieces you cut and trace them onto the remaining 405mm slat of wood, and cut with jigsaw.


  5. Step5_Sand

    Using your sander, sand all edges until they are soft and line up with each other.

  6. Step6_Drill

    a) Using your drill and a 3.2mm drill bit, drill 6 pilot holes that are spread evenly apart in the 355mm piece of wood. This is the piece you will use to connect the 6 vertical pieces.

    b) Next, drill 1 pilot hole in each of vertical pieces.

  7. Step7_Paint

    Now that you have sanded and cut pilot holes in your heart, paint or stain the pieces any colour that you want. We painted and stained every other piece.

    Leave to dry! (Follow instructions on paint or stain bottle for appropriate length of time.)

  8. Step8_Fasten Back

    Now that your pieces are dry, secure the 355mm slat to the back of your painted vertical pieces using screws and wood glue.

  9. Step9_Fasten

    First drill pilot holes where you want your cabinet knobs to be. Then screw in the knobs using accessories included in cabinet knobs packaging.

    Step9_Fasten Knob

  10. Attach hooks to back of 355mm wood using screws and brackets provided.

  11. Step11_Hang

    Fasten screws into wall and hang up your heart-shaped jewellery hanger!

    Optional Step: Find studs using stud detector. Screw into studs to ensure your jewellery hanger is supported.

Give Your Jewellery Some Love